DKS DoorKing 6300-384 1 Hp Dual Swing Gate Operator Kit

The DKS 6300 Swing Gate Operator is designed for residential, commercial, and industrial applications for both single and dual-leaf gates. The unique design of these operators allows the gate arm to be attached to the bottom rail of the gate. This eliminates the need for any brackets to be welded to the face of the gate and creates an aesthetically pleasing installation. The DKS 6300 Swing Gate Operator is designed to be pad or post mounted to meet almost any installation requirement. A post or pad mount is required for installation, specify mounting method when ordering. Standard Features: Self-adjusting, no maintenance magnetic limits Overlap feature for dual swing gate operation Designed with a built-in primary and secondary entrapment prevention system Ports for plug-in loop detectors Two convenience outlets Fail-safe release Tamper detect circuit Gate Tracker reporting output provides operator data to access control system* (*DKS systems with card access only) Programming switches Built-in reset switch Built-in power On/Off switch Class I, II, III and IV applications Compliant with UL 325 and 991. ETL Listed. (Note: To be compliant with UL 325 and industry safety guidelines, additional secondary entrapment prevention devices may need to be installed with this gate operator.) Specifications Operation 1 HP Continuous Duty Motor Primary Reduction Pulley / Belt Driving a Worm Gear Power Source 115VAC 60Hz 7.0Amp Max. Gate Weight 22 Ft. x 800 Lbs Max. Operating Speed Opens 90 degrees in 16 - 18 Seconds Max. Duty Cycle 60 Cycles Per Hour / Continuous Duty Operating Temperature 10 degrees F to 115 degrees F (-12 degrees C to 46 degrees C) Dimensions 13.25"W x 12"H* x 28"D (Operator Only - Actual Height Determined by Mounting Method) Warranty 5-Year Limited Factory Warranty