We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
NEW HOURS: 6:00AM - 5:00PM PST
NEW HOURS: 6:00AM - 5:00PM PST
ENFORCER Long-Range Barrier Sensors are ideal for protecting indoor or outdoor areas separated by long distances. They feature reliable photobeam technology with a choice of four programmable beam frequencies that provide superior perimeter protection by eliminating crosstalk and interference when multiple units are used. False alarms caused by animals, falling leaves, poor weather, or other sources are minimized by programming the alarm output  trigger operation.
ENFORCER Long-Range Barrier Sensors work in even the most extreme conditions. A built-in heater automatically turns on and off depending on the outside temperature. An environmental control system senses a slow degradation in beam strength when weather conditions worsen to help prevent  false alarms.
Installation and alignment is quick and easy with the ENFORCER Long-Range Barrier Sensors. They come with swiveling heads that allow them to be mounted along the same wall or on opposite walls, as well as provide for easy alignment of the beams between the transmitter  and receiver.
Â
Type | Long-Range Barrier Sensors for Indoor/Outdoor Access Control - Up to 380ft (120m) |
Number of Beams | 4 pairs |
Sensing Range | Outdoor- 190' (60m), Indoor- 380' (120m) |
Buzzer Active Current | 20mA@12VDC (RX) |
Heater Active Current | 160mA@12VDC (Rx+Tx) |
Rx Standby Current | (Buzzer off) 80mA, heater off (+/-25%@12VDC) |
Rx Trigger Current | (Buzzer on) 80mA, heater off (+/-25%@12VDC) |
Tx Standby & Active Current | 84mA, heater off, (+/-25%@12VDC) |
Input voltage | 12~24 VDC |
Operating Voltage | 12~24VDC |
Reaction time | 150/300/450/600 ms (DIP switch programmable) |
LEDs - Red | Alignment LED (Rx only), ON - beam is broken / OFF - aligned |
Detection System | Triggers as programmed when any 2 adjacent pair of beams are broken, or any single pair of beams is broken for over 2 sec. (programmable by JP2) |
Alarm Output | NO/NC/COM, relay output, active for 1 sec. when triggered |
Tamper Output | 1A@120VAC / 1A@24VDC (Tx & Rx) |
Case material | Aluminum housing / PC anti-UV cover / ABS end caps |
Operating Humidity | 0~95% |
Operating Temperature | -49º~131º F (-45º~55º C) |
Dimensions | 1-7/8" x 2-1/4" (49 x 55 mm) [Width x Height] |
Alignment Angle | Horizontal +/-90º |
Weight | 7.7-lb (3.5kg) [with brackets] |
Enclosure | IP65 |
Length | 43" (109cm) |
Â