Diablo Controls DSP-19 Plug-in, Low Power & Mini-Loop Vehicle Detector

FEATURES:

The DSP-19 is specifically designed to be installed into a LiftMaster® model CSW24 operator or other models that use the same plug-in loop detector. The very low current draw and low voltage range is ideal for solar applications.

The DSP-19 can be connected to a standard inductive loop or one of Diablo Controls mini-loops. The Diablo Controls mini-loop is a small “pipe shaped” device approximately 4-1/2” by 1” and is designed to be buried in the ground to detect vehicles. If the mini-loop feature is turned on, the detector cannot be used as a safety detector as there is no presence detection in this mode of operation. Contact Diablo Controls for more information on the mini-loop.

The DSP-19 can be used as either a safety loop or free exit loop detector. It also has the flexibility to be either “fail-safe” or “fail-secure”.

The DSP-19 has a single solid-state open-drain FET output capable of sinking more than 250 milliamps.

The DSP-19 has 10 selectable sensitivity settings and uses a 6-position DIP switch to configure the detector. This includes the Diablo Controls mini-loop selection as well as sensitivity boost, extended presence and fail-safe/fail-secure operation. This makes the DSP-19 very flexible and versatile for those installations that need a little more than a standard detector.

Failure Operation: In fail-safe, the detector will output a detect when the loop circuit is failed. In fail-secure, the detector will not output a detect when the loop circuit is failed. Set DIP switch 6 to off to operate in fail-safe mode. Set the switch to on to operate in fail-secure mode. Note: Never use a fail-secure detector for a safety loop.

Connector: Rear Molex Connector.
1: Loop or Mini-Loop
2: Loop or Mini-Loop
3: No Pin
4: N/C
5: N/C
6: N/C
7: N/C
8: Power – and Output common
9. Power +

Size: Height: 2.362″ Width: 0.866″ Depth: 2.008”