Diablo Controls AVI-X-2 Multiple Code AVI Transmitter

There are two models available:

• AVI-X-1 – constantly transmits its single code as long as power is applied to the unit.
• AVI-X-2 – transmit its primary code continuously unless the switch is pressed.

The transmitter is typically attached to the undercarriage of the desired vehicle and the two wires are hooked into the switched DC power source usually located someplace on the dashboard.

The transmitter comes factory preset with the programmed code(s) installed. The code(s) are easily changed if necessary. However, for security reasons, this must be done by the factory. Please contact the factory for any programmed code changes.

• Voltage:  12 VDC (10 to 15 volts DC) protected from momentary overvoltage and/or voltage reversal.
• Current:  20 to 80 mA depending on the code.
• Frequency:  375 kHz and complies with FCC part 15 for unlicensed operation.
• Codes:  Any two codes between 1 and 19,683 using the standard Motorola trinary format.
• Transmission Speed:  Code is transmitted once every 15 ms.
• Operating Temperature:  -30°F to 140°F (-34°C to 60°C).
• Humidity:  100% relative humidity.
• Fuse:  Recommend adding 1A fast-acting fuse prior to cable attachment points (Not included).
• Power Cable:  20’, two conductor cable.

Size:

• Base: 4.5” diameter x 1.0” high
• Bolt: 4.5” high
• Weight: 17 oz