Skip to the beginning of the images gallery

Diablo Controls AVI-40 10 Pin Plug In Multiple Code Receiver

$320.00

Over 19,000 codes to choose from
Can be programmed to accept up to 4 different codes
Operates on 8 to 35 volts DC
Can be field programmable with the “Learn” pushbutton
No switches to set
Small profile, perfect for many installations
Responds to transmitters made by other manufacturers

Availability: In stock

Learning: All Diablo Controls AVI receivers are shipped in the unprogrammed mode. Before the receiver can be used for AVI, it must first learn the acceptable codes. To program a new code, the transmitter transmitting this code must first be energized and placed over the loop. Press and hold the “Learn” button until the red Valid LED starts blinking fast. Then simply release the button. This will store the new code in memory. Once this new code is received and learned, it will now activate each time this code is received. The receiver has the capability of storing up to two codes. If the unit is asked to learn a third code, the oldest code is discarded.

To erase all the stored codes, disconnect the MS connector from the unit. With the pushbutton firmly pressed, reconnect the MS connector. Continue to press the button in until the red Valid LED begins to blink slowly. Release the pushbutton. There are now no codes stored in memory and the unit is ready to learn new codes

LED Indicators: The green Power LED will be on solid to indicate the unit is operating and powered. The red Valid LED will turn on when the unit is receiving a valid code. If the red Valid LED is blinking slowly then this unit is un-programmed and has no codes stored to validate.

Outputs: Solid-state (open transistor collectors) for both detect and fail outputs. 30 mA maximum current sink- transient voltage protected.

Power: 12 to 30 volts DC

Operating Temperature: -35°F to 165°F (-37°C to 74°C)

Size: Height: 2.4″ (61 mm) Width: 0.8″ (20 mm) Depth: 2.25” (57 mm)

Connector: 10-position Molex Type 09-48-1104
Mates with many female PCB 0.156” pitch headers in use by some access control devices and gate operators.

Pin assignments are:
1 – Loop input
2 – Loop input
3 – Power in (+12 / 24 VDC)*
4 – Unused
5 – Unused
6 – Unused
7 – Unused
8 – AVI Output solid state
9 – Power in (+12 / 24 VDC)*
10 – Chassis Ground
*Either or both of these pins can be used to supply power to the detector.

More Information